Water Dosing DN40 - by progressive cavity helical pump, vector control for volumes 2:25 m³ / h, magnetic flow meter with resolution > 0.2 l
Maximum precision in water dosing
The homogeneity of the concrete allows us that the automatic machines, those for manufacturing alveolar plates, beams, blocks, pipes, paving stones, sleepers, etc. reduce defects, increase productivity due to fewer adjustments, more quality due to its uniformity in color, texture, finish, etc. in the filling of molds for the settlement or workability index, with calculation procedures for the evaporation of water due to the effect of temperature. Facilitating the performance of each cubic meter of manufactured concrete and with maximum simplicity for the operator, more than 35 years of experience and new technologies have allowed us to develop the equipment: DA40-2: 25m3/h -CM and in the T2000CA control.
The team's strategy is mainly based on these points:
- Compact equipment, coupling, tested and with calibration certificate.
- Accuracy in the total dosage of water greater than + / - 0.2%, repeatability + / - 0.1%.
- Water speed according to dosing processes of 0.45 m / s 6.0 m / s.
- Water volumes according to processes approximately from 0.5 l/s to 7.0 l/s.
- 600L water tank, to maintain NPSHr. (Net positive suction height)
- Open loop vector control pump + / - 0.01% of maximum frequency.
- Water pump, no mixture by sprinkler arm and flat jet on the mixture at 25 º.
- Particular water procedures in the Tecnologia Automàtica Industrial SA SCADA